Description
1 new tube 3Bond / DreiBond 1209 silicone sealant Made in Germany
– content 30ml
– recommended by Porsche and BMW and corresponds to BMW No. 07 58 9 062 376
PRODUCT FEATURES
High performance silicone with very high temperature resistance up to 200/250°C. Very good long-term temperature behaviour. In the cured state, good chemical resistance to common industrial media.
AREA OF APPLICATION
For all surface and flange seals in engine, gearbox, axle and drive applications with high compressive strength, very high tear resistance and increased adhesion.
– Oil pan
– Oil pump, oil pump cover
– Oil filter holder
– Intermediate flange / sealing flange
– Water pump
– Intake manifold
– Cylinder head bearing cover
– Timing case / Engine block
– Chain case cover
– Gearbox housing
– Differential and gearbox cover
PRODUCT ADVANTAGES
– Immediate sealing when laid flat, allowing full-load operation after installation.
– Moisture and oil contact accelerate curing.
– Permanently elastic long-term behaviour guaranteed even in the high-temperature range.
– Very good ageing resistance.
– Normal disassembly still possible.
– Low inherent odour in the cured state.
PHYSICAL PROPERTIES
Delivery form pasty
Colour colourless
Viscosity at 25°C > 500.000 mPa.s according to Brookfield
Density according to DIN 51757 ~ 1.09 g/ml
Temperature range -55° to 200/250°C
Skin formation approx. 10 – 15 min
Elongation at break DIN 53504 > 300%.
Hardness Shore A DIN 53505 approx. 45
SAFETY INFORMATION
Contains butane-2-on-O,O`,O”-(methylsilylidyn)trioxime, butane-2-on-O,O`,O”-(vinylsilylidyn)trioxime, 3-aminopropyltriethoxysilane, 2-butanonoxime
Caution: Causes skin irritation. May cause allergic skin reactions, Causes severe eye irritation.
Wear protective gloves/protective clothing/eye protection. In case of skin irritation or rash or if eye irritation persists:
Seek medical advice/attention.
Wash contaminated clothing before reuse.
